Bay Bridge opening delayed until at least December

SACRAMENTO, Calif. (AP) — The eastern span of the San Francisco-Oakland Bay Bridge will not open as scheduled on Labor Day as it will take contractors until at least December to repair cracks in the bridge’s seismic safety bolts, the Toll Bridge Program Oversight Committee announced Monday.

A new opening date for the $6.4 billion crossing will be decided after the retrofit of the failed bolts is completed, which is estimated to take until at least Dec. 10, the committee said in a report.

It will take that long to make and install a steel saddle that will perform the same function as the failed bolts, Bay Area Toll Authority executive director Steve Heminger said.

“You might look at it as, our belt broke and we are putting on some suspenders,” said Heminger, who also is chairman of the three-member oversight committee. “We are sorry, we are very sorry for this delay….We will be opening a safe new bridge for (commuters) as quickly as we are able to do so.”

It is unclear how long it will take to manufacture the saddle, but it will take up to two months to install the saddle, he said. That delay will create complications because of worsening weather in the fall and because transportation officials had been counting on a three-day Labor Day holiday to finish their work. Engineers will need to shut down the existing bridge for four days as they make final adjustments to divert traffic onto the new span.

However, engineers’ review of other bolts throughout the structure have not found further problems, easing concerns that they could also have become brittle from the exposure to hydrogen. The other bolts have been in place and under tension for three months to four years without failing, Heminger said.

“We do not believe there is any further danger” from failed bolts because the others have been performing as designed, he told reporters after briefing four state senators at the Capitol.

However, there is a longer term danger from what is known as “stress corrosion.” Engineers can deal with that stress corrosion after the bridge opens to traffic, he said.

Exposure to hydrogen was the root cause for why 32 seismic safety bolts becoming brittle and cracking after they were tightened in March, according to the report. The problem is considered a short-term phenomenon that occurs in metals when certain conditions apply. In the case of the rods on the Bay Bridge, the report said the “metallurgical condition of the steel was found to be less than ideal.”

The bridge is replacing the span damaged during the 1989 Loma Prieta earthquake, and the new project is already years late and billions over budget.

Monday’s report indicates that officials overseeing the project altered the original plan for treating the high-strength steel rods on the span. Initial bridge specifications required the rods to be mechanically galvanized, subjecting them to less heat and potential embrittlement than a method called hot-dip galvanizing in which the steel is “dipped into a bath of molten zinc at approximately 850 degrees Fahrenheit.”

But contractors and Caltrans design staff determined that the 3-inch and 4-inch diameter tower rods being used were “too long and too heavy for the mechanical process.” The decision was based partly on Caltrans’ experience with the retrofit of the Richmond-San Rafael Bridge, where the hot-dip galvanizing method was used and rods were tightened under water, the report said.

“There is little documented discussion regarding the variety of applications and far higher tension levels that would be placed on some of the high-strength rods on the (Bay Bridge) and potential alternative corrosion protection methods,” the report said.

The opening of the bridge has been in doubt as crews work to install the repair for the cracked seismic safety bolts — important pieces that hold a shock-absorber-like piece called a “shear key” to the bridge deck so that the structure can move safely during a quake.

Bridge officials say the bridge will not open unless it is deemed safe to do so.

However, officials also say moving traffic onto the new span is important to public safety, as the existing crossing is not considered earthquake safe.


Associated Press writer Juliet Williams also contributed to this report.

WKBN 27 First News provides commenting to allow for constructive discussion on the stories we cover. In order to comment here, you acknowledge you have read and agreed to our Terms of Service. Commenters who violate these terms, including use of vulgar language or racial slurs, will be banned. No links will be permitted. Please be respectful of the opinions of others. If you see an inappropriate comment, please flag it for our moderators to review.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s